Справочник Пользователя для National Instruments NI PXI-8104

The NI PXI-8104 controller is designed for easy handling. To remove the 
unit from the PXI chassis, complete the following steps:

1.

Power off the chassis.

2.

Remove any cables that may be attached to the controller front panel. 

3.

Unscrew the bracket-retaining screws in the front panel. Refer to 
Figure 2-1 for the location of these screws.

4.

Press the injector/ejector handle down.

5.

Slide the unit out of the chassis.

You can change the NI PXI-8104 configuration settings in the BIOS setup. 
The BIOS is the low-level interface between the hardware and PC software 
that configures and tests your hardware when you boot the system. The 
BIOS setup program includes menus for configuring settings and enabling 
NI PXI-8104 controller features.

Most users do not need to use the BIOS setup program, as the NI PXI-8104 
controller ships with default settings that work well for most 
configurations.

Changing BIOS settings may lead to incorrect controller behavior and possibly 

an unbootable controller. If this happens, follow the instructions for restoring default 
settings in the 

 section. In general, do not change a setting unless you are 

absolutely certain what it does.

To start the BIOS setup utility, complete the following steps:

1.

Power on or reboot your NI PXI-8104 controller.

2.

When the message 

 appears, press 

the Delete key on the keyboard. The message 

 

appears, and the setup program is loaded after a short delay.

3.

When you first enter the BIOS setup program, it displays the Main 
menu.