Справочник Пользователя для Chamberlain 3585s 3-4 hp

34

NOTE: Your new Keyless Entry must be programmed to operate your garage door opener.
USING THE “LEARN” BUTTON 

1.  Press the PROG <Learn> button on 

the Smart Control Panel

TM

.

2.  Press the PROG <Learn> button 

again to confirm Learn Mode.

3.  Enter a four digit personal 

identification number (PIN) of your 
choice on the keypad. Then press 
enter.

4.  When the motor unit lights blink, it 

has learned the code. If light bulbs 
are not installed, two clicks will be 
heard.

To change an existing, known PIN
If the existing PIN is known, it may be changed by one 
person without using a ladder.
1.  Press the four buttons for the present PIN, then press 

and hold the # button.

   The opener light will blink twice. Release the # button.
2.  Press the new 4-digit PIN you have chosen, then 

press Enter.

The motor unit lights will blink once when the PIN has 
been learned.
Test by pressing the new PIN, then press Enter. The door 
should move.

To set a temporary PIN
You may authorize access by visitors or service people 
with a temporary 4-digit PIN. After a programmed number 
of hours or number of accesses, this temporary PIN 
expires and will no longer open the door. It can be used to 
close the door even after it has expired. To set a 
temporary PIN:
1.     Press the four buttons for your personal entry PIN (not 

the last temporary PIN), then press and hold the 

✽ 

button.

   The opener light will blink three times. Release the 

button.

2.  Press the temporary 4-digit PIN you have chosen, 

then press Enter.

  The opener light will blink four times.
3.  To set the number of hours this temporary PIN will 

work, press the number of hours (up to 255), then 
press 

✽.

3.  To set the number of times this temporary PIN will 

work, press the number of times (up to 255), then 
press #.

The opener light will blink once when the temporary PIN 
has been learned.
Test by pressing the four buttons for the temporary PIN, 
then press Enter. The door should move. If the 
temporary PIN was set to a certain number of openings, 
remember that the test has used up one opening.To 
clear the temporary password, repeat steps 1-3, setting 
the number of hours or times to 0 in step 3.

One Button Close: Opener can be closed by pressing only the ENTER button if the one button close feature has been 
activated. This feature has been activated at the factory. To activate or deactivate this feature press and hold buttons 1 
and 9 for 10 seconds. The keypad will blink twice when the one button close is active. The keypad will blink four times 
when one button close is deactivated.

1.  Press and release the “learn” button 

on motor unit. The learn indicator 
light will glow steadily for 30 
seconds.

2.  Within 30 seconds, enter a four digit 

personal identification number (PIN) 
of your choice on the keypad. Then 
press and hold the ENTER button.

3.  Release the button when the motor 

unit lights blink. It has learned the 
code. If light bulbs are not installed, 
two clicks will be heard.

LOC

K

LIGH

T

LOC

K

LIGH

T

LO

CK

LIG

HT