Справочник Пользователя для Vulcan Materials wolf vcm36

 
- 

5

 - 

  The cheesemelter and its parts are hot.  Use care when operating, 

Cheesemelters mounted on a counter must be equipped  
with 4" (10 cm) legs(sold separately).  Screw the legs  
into the threaded attachment points on the bottom of the 
unit. The countertop must be of noncombustible  
construction.  Place Cheesemelter in position, then level 
by adjusting the bullet feet.  
 

1. Make sure brackets are level and properly spaced  
    so that bracket holes will align with the threaded  
    attachment points on the bottom of the unit.  
 
2. Mount the brackets only in the upside-down “L” 
    position as shown. 24 thru 48 models require two 
    brackets while 60 and 72 models require three 
    brackets for proper support. 
  
3. Secure brackets to wall by means of lag screws or  
    bolts. Make sure the lag bolts or screws engage  
    wall studs. 
 
4. Place unit into position on the brackets, making sure 
    that the unit’s bottom threaded attachment points 
    are aligned with the holes in the brackets. 
  
5. Secure unit into position with four (24 to 48 models) 
    or six (60 and 72 models) 3/8” bolts. Thread the bolts   
    through the holes in the brackets and into the threaded 
    attachment points on the bottom of the unit. 
 

If the Cheesemelter is to be mounted over a Gas Range,  
a reinforced hi-shelf designed for that range is required. 
  
1. Place and align Cheesemelter on top of shelf brackets;  
    place the back of the unit flush with the rear of the shelf. 
 
2. Align holes in the shelf with the threaded attachment 
    points on the bottom of the cheesemelter.  
 
3. Secure cheesemelter into place with four 3/8” bolts .  
    Thread the bolts through the shelf and into the threaded  
    attachment points at each corner of the cheesemelter.