Справочник Пользователя для National Instruments TPC-2512
Chapter 2
System Setup
2-4
ni.com
Panel Mounting
Follow these steps to mount the TPC-2012/TPC-2512 in a panel:
1.
Be sure the adhesive waterproof gasket on the front bezel is in position.
2.
Install the TPC-2012/TPC-2512 in the panel opening. (Refer to
Appendix A,
Appendix A,
, for cutout dimensions.)
3.
Hook the clamps included in the accessory pack to the holes around the
four sides of the bezel.
four sides of the bezel.
4.
Insert the screws included in the accessory pack into the clamps. To
fasten the TPC-2012/TPC-2512 to the panel, tighten the screws so they
push against the mounting panel.
fasten the TPC-2012/TPC-2512 to the panel, tighten the screws so they
push against the mounting panel.
Note
The mounting panel thickness should be less than 6 mm (0.236 in.).