Справочник Пользователя для National Instruments 321042A-01
Chapter 2
Hardware Configuration and Installation
© National Instruments Corp.
2-3
STD-GPIB for Windows
Note:
If you plan to perform HS488 high-speed protocol transfers, you must
configure the NI-488.2 software for the amount of GPIB cable length in
your system. The 5 in. GPIB ribbon cable must be added to your total
GPIB cable length.
configure the NI-488.2 software for the amount of GPIB cable length in
your system. The 5 in. GPIB ribbon cable must be added to your total
GPIB cable length.
5.
Mount the feedthrough panel assembly onto the STD/STD32 card cage using the two
large thumbscrews.
large thumbscrews.
6.
Check that the installation resembles Figure 2-2.
ON
OFF
1
2
1
Feedthrough Panel Assembly
2
Thumbscrews
Figure 2-2. Completed Installation for the STD-GPIB
7.
Power on your system.
After you have installed your STD-GPIB, you are ready to install the NI-488.2 software.
Refer to Chapter 3, Software Installation and Configuration .
Refer to Chapter 3, Software Installation and Configuration .