Справочник Пользователя для National Instruments 321042A-01

The software installation begins with the following screen:

The interactive Windows setup program takes you through the necessary steps to
install the NI-488.2 software.  For help during the installation, press the Help  button.
You can exit the setup at any time by pressing the  Exit  button.

3.

After the installation is complete, restart your system.

After you have installed your software, you might want to view or modify the driver
configuration.  If you modified the hardware configuration, or if you installed more than
one STD-GPIB, you must reconfigure the software.  Refer to the next section for
instructions on running the GPIB software configuration utility.  If you do not need to
configure the software, refer to Chapter 4,  Installation Verification and Troubleshooting,
for instructions on verifying the hardware and software installation.

The GPIB software configuration utility is an interactive utility that you can use to
examine or modify the configuration of the driver, including enabling or disabling DMA
and interrupts.  Run the software configuration utility and make sure the software settings
match the switch and jumper settings on your board.  For example, if you used the default
IRQ disabled setting on the board, change the IRQ setting in the configuration utility to
None.