Справочник Пользователя для Dakota Digital lat-nr411

 

 

7.  Insert each new LED assembly through the hole where the original bulb and connector were 

located.  Use caution when feeding the wires through the socket opening to avoid damaging 
the wire insulation. 

 
8.  Feed the wires through the large hole in the back plate and attach the 

back plate onto the back side of the housing. The flat side of the 
mounting plate should be toward the outside and the side with the 
slight raised center should go in towards the housing.  This will align 
the mount in the original housing. 
 

 
9.  Secure the LED assembly into the housing with the supplied back plate and #6 lock nuts. 

 

 

10. Place the original lens gasket into place and replace the tail light lens.   

 

 

MAN#650248