Справочник Пользователя для Grizzly G9861
-18-
Ultimate Series Jointers
1.
Place a 45° gauge on the outfeed table fair-
ly close to the cutterhead as shown in
ly close to the cutterhead as shown in
Figure
16
.
45° Fence Stop
Figure 16.
Using a 45° gauge to align fence.
2.
While holding the fence adjusting handle,
loosen the angle setting lock knob and the
checknut on the 45° stop screw as shown in
loosen the angle setting lock knob and the
checknut on the 45° stop screw as shown in
Figure 17
. Turn the stop screw against the
sliding bracket until the fence contacts the
edge of the 45° gauge evenly.
edge of the 45° gauge evenly.
3.
Tighten the checknut on the stop screw and
tilt the fence forward, then back against the
stop.
tilt the fence forward, then back against the
stop.
4.
Recheck with the 45° gauge. Tightening the
checknut will move the stop bolt slightly, so
some trial-and-error may be necessary to
perfect your settings.
checknut will move the stop bolt slightly, so
some trial-and-error may be necessary to
perfect your settings.
Figure 17.
Setting the 45° stop.
45° Stop