Справочник Пользователя для Cabletron Systems brim f6 brim-f6

Chapter 2: Installation

Press down firmly on the FPIM until the pins slide all the way into the 
HSIM connector.

Secure the FPIM with the screws saved in 

Secure the faceplate of the HSIM with the screws saved in 

You can install an HSIM in any Cabletron Systems device that supports 
HSIM technology (e.g., 2E42-27, 6E132-25). Refer to the release notes 
for the version of firmware running on the Cabletron Systems device to 
ensure that the HSIM-F6 is supported. The following subsections provide 
generic instructions for installing an HSIM-F6 in an interface module or 
in a standalone hub. Refer to your specific interface module or standalone 
hub documentation for exact HSIM slot and connector locations.

To install an HSIM-F6 in an interface module that supports HSIM 
technology perform the following steps.

Note the ports of the interface module that have cables attached to 
them. Then disconnect those cables from the ports.

Attach the antistatic wrist strap (refer to the instructions outlined in the 
interface module User’s Guide).

Unlock the top and bottom plastic locking tabs of the module 
faceplate.

Only qualified personnel should install or service this unit.

The HSIM-F6 and the host module or standalone hub are 
sensitive to static discharges. Use an antistatic wrist strap and 
observe all static precautions during this procedure. Failure to 
do so could result in damage to the HSIM-F6, the host module 
or standalone hub.