Справочник Пользователя для Barco DICOM THEATER LITE MGP D5
RS 232 AND LAN CONTROL
User Guide
38
MGP D5
RS 232 AND LAN CONTROL
RS 232
You may control and monitor the projector remotely through the
serial RS232 control interface.
serial RS232 control interface.
The RS232 protocol is a binary protocol where each command is a
series of 32 bytes in one packet. The protocol allows for both SET
and GET operations. To utilize GET operations the host needs a
routine for receiving and interpreting incoming packets. SET-
operations are used to force the projector into different modes,
like setting brightness and contrast, switching between sources,
etc.
series of 32 bytes in one packet. The protocol allows for both SET
and GET operations. To utilize GET operations the host needs a
routine for receiving and interpreting incoming packets. SET-
operations are used to force the projector into different modes,
like setting brightness and contrast, switching between sources,
etc.
A separate document “RS-232 and LAN communication protocol
and command set” is available that describes the
communications parameters and operational codes in detail.
and command set” is available that describes the
communications parameters and operational codes in detail.
LAN
The projector can be controlled and monitored using through the
LAN connector as an alternative to RS232.
LAN connector as an alternative to RS232.
LAN control is based on the same command set as RS232.
NOTE! THE PROJECTOR IS CONFIGURED WITH A DEFAULT IP ADDRESS.
SEE THE SYSTEM INFORMATION AVAILABLE THROUGH THE MENU
SYSTEM OR REMOTE CONTROL FOR THE ACTUAL IP-ADDRESS.
SEE THE SYSTEM INFORMATION AVAILABLE THROUGH THE MENU
SYSTEM OR REMOTE CONTROL FOR THE ACTUAL IP-ADDRESS.
Detailed descriptions of configuration, use and command set is
described in a separate document “RS-232 and LAN
communication protocol and command set”.
described in a separate document “RS-232 and LAN
communication protocol and command set”.
You may consider using the LAN interface as a means of theft-
detection. When the projector is removed, the LAN will be
disconnected; this may be detected over the local area network
and could be used to trigger an alarm.
detection. When the projector is removed, the LAN will be
disconnected; this may be detected over the local area network
and could be used to trigger an alarm.