Справочник Пользователя для National Instruments SCC-AI07

© National Instruments Corporation

If you configured the SCC-AIXX using MAX and you are using NI-DAQ, 
the voltage reading you get from the E Series DAQ device accounts for the 
voltage scaling effect of the SCC-AIXX. Otherwise, since the voltage 
measurement from the E Series DAQ device is scaled by the gain given in 
Table 1-1, you must divide the voltage reading returned by the E Series 
DAQ device by this gain to get the correct input voltage.

These ratings are typical at 25 °C unless otherwise stated.

Number of input channels ...................... 2 NRSE

Isolation.................................................. Bank isolation (isolation 

per module)

1

Input/output signal range, gain, 
and bandwidth ........................................ Refer to Table 1-1

Input impedance

SCC-AI01, SCC-AI02 .................... 1 M

Ω 

All others......................................... 100 M

Ω

Gain error ............................................... 4.5% max (trimmable to zero)

Gain stability .......................................... 150 PPM/

°C

Offset error ............................................. 40 mV max (RTI

2

)

Offset stability........................................ 225 

µV/°C

Nonlinearity ........................................... 0.0128% typ

0.0260% max

Common-mode rejection ratio ............... 100 dB typical at 60 Hz

Output slew rate,
dependent on BW (filtering) .................. 0.8 V/

µs max

1   

The SCC-AIXX does not provide isolation between the two channels of the module. For more information on this topic, 
refer to the 

 section.

2   

This specification is calculated relative to the input range of the module.