Справочник Пользователя для Konica Minolta 7145i gev2

The Punch mode is available when one of the following Finisher options is installed in
the machine.
FS-113 Finisher:
When the Punch mode is selected in combination with any of the Stack, Sort, Staple,
and Group modes, each copied sheet is punched and output to the primary (main)
according to the selected output mode. The secondary (sub) tray provides the Stack
mode only.
FS-114 Finisher:
When the Punch mode is selected in combination with the Stack, Sort, Staple, and
Group modes, each copied sheet is punched and output to the tray selected (tray 1, 2
or 3 if installed), according to the selected output mode.

❒ Be sure that the side guide plates of the paper tray are securely aligned to the 

paper; otherwise the copies may not be punched in position.

❒ If the ATS (Automatic Tray Switching) functions while the machine uses the Punch 

mode, the punch holes may be slightly off the appropriate positions.

❒ Number of punch holes: 4 holes

❒ Hole diameter: 6.5 mm ± 0.5 mm

❒ Hole pitch: 80 mm ± 0.5 mm

❒ Copy paper size: A3, B4, F4, A4, B5

Load the A4/B5 size paper in portrait orientation. If loaded in landscape orientation, 
copied paper will be output without being punched.

❒ Paper weight: 60 ~ 90 g/m

2

 (80 g/m

2

 paper recommended)

❒ Incompatible with Punch mode: Using platen glass (unless Image Insert, Dual 

Page, or Platen store mode is used), Booklet, OHP Interleave, Non-Image Area 
Erase, Repeat, AUTO Layout

FS-113 Finisher

FS-114 Finisher
 + PK-114 Punch kit
 + SK-114 Saddle kit

FS-114 Finisher
 + PK-114 Punch kit