Справочник Пользователя для Frigidaire 137153100a (0903)
6
Grounding type
Grounding type
wa
wa
wall receptacl
ll receptacle
Po
Power cord with
wer cord with
3-prong
3-prong gr
grounded plug
ounded plug
Do not,
Do not, under
under
an
any cir
y circumstances,
cumstances,
cut,
cut, remo
remove
ve,
or b
or bypass th
ypass the
gr
grounding pr
ounding prong.
ong.
CABLE TIE
Connecting drain and electrical
Form a “U” shape on the end of the drain hose with the hose
1.
pointed toward the drain. Place the formed end in a laundry
tub or a standpipe and secure with a cable tie provided in the
enclosure package.
tub or a standpipe and secure with a cable tie provided in the
enclosure package.
Place the hook end of the drain hose in the drain opening.
2.
Secure the drain hose with the cable tie (provided in the
enclosure package) to the standpipe, inlet hose, laundry tub,
etc. so the hose does not pull out from the force of the water.
enclosure package) to the standpipe, inlet hose, laundry tub,
etc. so the hose does not pull out from the force of the water.
Plug the power cord into a grounded outlet.
3.
Turn on the power at circuit breaker/fuse box.
4.
Carefully slide the washer to its fi nal position. Recheck for level
5.
and rock corners for stability.
Read the Use & Care Guide provided with the washer. It
6.
contains valuable and helpful information that will save you
time and money.
time and money.
Run the washer through a complete cycle, checking for water
7.
leaks and proper operation.
If you have any questions during initial operation, please review
8.
the “Service Prevention Checklist” in your Use & Care Guide
before calling for service.
before calling for service.
Place these instructions in a location near the washer for future
9.
reference.
A wiring diagram and technical data sheet are
located inside the washer console.
Replacement parts:
If replacements parts are needed for your washer, contact the
source where you purchased your washer.
source where you purchased your washer.
- ELECTRICAL SHOCK HAZARD - Label all
wires prior to disconnection when servicing controls. Wiring
errors can cause improper and dangerous operation. Verify
proper operation after servicing.
errors can cause improper and dangerous operation. Verify
proper operation after servicing.
Check to ensure the power is off at circuit
breaker/fuse box before plugging the power cord into outlet.
The standpipe inside diameter must be 1-1/4” (3.2
cm) minimum. There must be an air gap around the drain hose
in the standpipe. A snug hose fi t can cause a siphoning action.
in the standpipe. A snug hose fi t can cause a siphoning action.