Справочник Пользователя для GE ZKD910

7

Installation

When installed below a single or double oven, check

to be sure that any oven supports above the cutout  do not obstruct

the 23-1/2” required depth of the warming drawer cutout.

• A 2” min. clearance between oven and

warming drawer cutouts are required.
Additional clearance may be required if 2 x 4
blocks are used to support runners or solid
floor of the oven above.

• The warmer drawer may be supported by

either a solid bottom,  2 x 4  or 2 x 2 runners.

• The support must be level and rigidly

mounted, flush with the bottom edge of the
cutout.
– There is no way to level the drawer once it

has been installed. Be sure supports are
level.

• The entire weight of the drawer is supported

by the runners or solid floor and must be
capable of supporting 150 lbs.

• Slide left corner of the drawer into the

opening.

• Push power cord into the hole leading to the

outlet location. Thread the cord through as
drawer is being pushed back into the open-
ing. Check to be sure power cord does not
get trapped under the drawer.
– If the outlet is installed inside the opening,

plug the cord into the outlet. Coil power
cord and secure to warming drawer side
with power cord clip.

• Push the drawer back until the front flange is

flush to the cabinet front.

• Open the drawer fully.
• Drill pilot holes through the holes in the

overlaping frame, one on each corner.

• Drive wood screws provided into each

corner.

23-1/2"

22"

27"

2"x 4" or
Equivalent Runners

23-1/2"

25"

30"

2"x 4" or
Equivalent Runners

9"

2x4 or 2x2

Runners or Solid

Bottom

Install

2x4 or 2x2

Anti-Tip Block 

Against Rear 

Cabinet Wall

9" From Floor 

to Bottom

of Block