Справочник Пользователя для briggs--stratton 355z

Operation

 1.  Disengage the PTO, engage the parking brake, 

turn off the ignition, remove the key, and wait for all 
moving parts to stop.

 2.  Remove the cutting height pin and lower the 

attachment lift to its lowest position.

 3.  Pivot the front wheels out of the way and slide the 

mower deck under the unit.

 4.  Install the leveling links (I & J, Figure 12) and hair 

pins (C & D).

 5.  Lift the rear of the mower deck and install the rear 

lift rods (K & L) and secure with the rear rod locks 
(E & F).

 6.  44” & 50” Simplicity Models Only: Install the 

roller bar connecting rod (M) and the hair pin.

 7.  Lift the front of the deck using a 2 x 4 as a lever, 

pull the handle (G) to align the front hanger rod 
ends (H) with the slots and secure with the front 
rod locks (A & B).

 1.  Reinstall the belt and make sure that it is properly 

seated in all pulleys.

    44” & 50” Mower Decks:

 a.  Install the belt as shown in Figure 10.

 b.  Release tension from the tensioning idler pulley 

using the belt tension lever (D) and make sure the 
belt is seated properly in all pulleys.

 a.  Install the belt on the arbor pulleys (A, Figure 10), 

back-side idlers (B) as shown in Figure 9.

 b.  Rotate the belt tension release lever (D) to relieve 

the tension on the belt and install the belt on the 
PTO pulley (C)

 c.  Carefully release the tension on the on the belt 

tension release lever and make sure the belt is 
seated properly in all pulleys.

    54” Mower Decks:

 a.  Install the belt on the PTO pulley (C, Figure 10), 

the arbor pulleys (A), and all back-side idlers (B) 
except for the stationary idler pulley (B, Figure 11).

 b.  Carefully rotate the breaker bar COUNTER-

CLOCKWISE and install the belt on the stationary 
idler pulley.

 c.  Carefully release the tension on the breaker bar 

and make sure the belt is seated properly in all 
pulleys.

Not 

for  

Reproduction