Справочник Пользователя для briggs--stratton 355z

 1.  Park the rider on a smooth, level surface such as 

a concrete floor.  Disengage the PTO, engage the 
parking brake, turn off the engine, and remove the 
ignition key.

 2.  Remove the PTO drive belt (see MOWER BELT 

REPLACEMENT for removal instructions).

 3.  Loosen the nut towards the front of the machine on 

the spring anchor hook (H, Figure 47) to release 
the majority of the belt tension.  Use caution and 
remove the nut to completely release the tension.

 4.  Remove the old belt and replace it with the new 

one.  Make sure the V-side of the belt runs in the 
grooves of the crankshaft pulley and transmission 
pulleys (B & C).

 5.  Reinstall the anchor hook (H) into the anchor tab 

and loosely fasten the nut.  Adjust the spring until 
a measurement of 9” (22,86cm) is achieved from 
the outside of the spring hooks.  Tighten nut.

 6.  Reinstall the PTO drive belt.

A dead battery or one too weak to start the engine 
may be the result of a defect in the charging system or 
other electrical component.  If there is any doubt about 
the cause of the problem, see your dealer. If you need 
to replace the battery, follow the steps under Cleaning 
the Battery & Cables in the Regular Maintenance 
Section.

To charge the battery, follow the instructions provided 
by the battery charger manufacturer as well as all 
warnings included in the safety rules sections of this 
book.  Charge the battery until fully charged.  Do not 
charge at a rate higher than 10 amps.

Troubleshooting, Adjustments, & Service

Not 

for  

Reproduction