Справочник Пользователя для DSC power864

Скачать
Страница из 36
I n t r o d uc t i o n :   F i r e  D e t e c t i on
5
Fire Detection
This equipment is capable of monitoring fire detection devices such as smoke detectors and 
providing a warning if a fire condition is detected. Good fire detection depends on having 
an adequate number of detectors placed in appropriate locations. This equipment must be 
installed in accordance with NFPA 72 (N.F.P.A., Batterymarch Park, Quincey MA 02269). 
Carefully review Section 6:“Fire Safety” on page 22.
NOTE:
 Your installer must enable the fire detection portion of this equipment for 
it to work.
Testing
To make sure your system continues to work as intended, you must test your system weekly. 
Please refer to “Testing Your System” on page 18. If your system does not work correctly, 
call your installer for service.
Remote 
Monitoring
This system can send alarms, troubles and emergency messages over telephone lines to a 
central station (this must be enabled by your installer). If you accidentally initiate an alarm, 
immediately call the central station to prevent an unnecessary response.
By default, an alarm transmission can be cancelled by entering a valid access code within 30 
seconds of the alarm.
Maintenance
With normal use, the system requires minimum maintenance. Note the following points:
1. Do not wash the security equipment with a wet cloth. Light dusting with a slightly 
moistened cloth should remove normal accumulations of dust.
2. Use the system test described in “Testing Your System” on page 18 to check the battery 
condition. We recommend, however, that the standby batteries be replaced every 3 years.
3. For other system devices such as smoke detectors, passive infrared, ultrasonic or micro-
wave motion detectors or glassbreak detectors, consult the manufacturer’s literature for 
testing and maintenance instructions.