Справочник Пользователя для Zebra 49834
106
170PAX4 Maintenance Manual
57518L-001 Rev. A
3/18/05
Troubleshooting
LCD Error Messages
The print engine stops and
ERROR light flashes.
ERROR light flashes.
Caution • The printhead may be hot enough to cause severe
burns. Allow the printhead to cool.
burns. Allow the printhead to cool.
Caution • Observe proper electrostatic safety precautions when
handling any static-sensitive components such as circuit boards
and printheads.
handling any static-sensitive components such as circuit boards
and printheads.
The printhead is over temperature.
Allow the print engine to cool.
Printing automatically resumes when
the printhead elements cool to an
acceptable operating temperature.
Printing automatically resumes when
the printhead elements cool to an
acceptable operating temperature.
The print engine stops and
ERROR light flashes.
ERROR light flashes.
Caution • An improperly connected printhead data or power cable
can cause this error message. The printhead may be hot enough
to cause severe burns. Allow the printhead to cool.
can cause this error message. The printhead may be hot enough
to cause severe burns. Allow the printhead to cool.
Caution • Observe proper electrostatic safety precautions when
handling any static-sensitive components such as circuit boards
and printheads.
handling any static-sensitive components such as circuit boards
and printheads.
The printhead is under
temperature.
temperature.
Continue printing while the printhead
reaches the correct operating
temperature. If the error remains, the
environment may be too cold for
proper printing. Relocate the print
engine to a warmer area.
reaches the correct operating
temperature. If the error remains, the
environment may be too cold for
proper printing. Relocate the print
engine to a warmer area.
The printhead data cable is not
properly connected.
properly connected.
Caution • You must turn off the print
engine before performing this
procedure. Failure to do so can
damage the printhead.
engine before performing this
procedure. Failure to do so can
damage the printhead.
1.
Turn off (O) the print engine.
2.
Disconnect and reconnect the data
cable to the printhead.
cable to the printhead.
3.
Ensure that the cable connector is
fully inserted into the printhead
connector.
fully inserted into the printhead
connector.
4.
Turn on (I) the print engine.
Table 11 • LCD Error Messages (Continued)
LCD Display/
Print Engine Condition
Print Engine Condition
Possible Cause
Recommended Solution
WARNING
HEAD TOO HOT
WARNING
HEAD COLD