Справочник Пользователя для Zebra 49834
Preventive and Corrective Maintenance
Printed Circuit Boards—Main Logic Board
57518L-001 Rev. A
3/18/05
170PAX4 Maintenance Manual
237
Enter Printhead Resistance Value
1.
Enter the resistance value of the printhead, as was located in
.
2.
Press SETUP/EXIT to enter Setup mode.
3.
Press NEXT until the printer displays
HEAD RESISTOR
.
4.
Press the right arrow.
The LCD displays
ENTER PASSWORD
.
5.
Use the left and right arrows to enter the default password for your printer. The default
password is 1234.
password is 1234.
6.
Press NEXT.
7.
Use the left and right arrows to enter the printhead resistance value for your printer.
8.
After you have entered the printhead resistance value, press SETUP/EXIT.
The LCD displays
SAVE CHANGES
.
9.
If necessary, press the left or right arrow until the printer displays
PERMANENT
.
10.
Press NEXT.
11.
Verify that the printer is operating correctly.
If you had previously made changes to the default configuration, you need to make those
changes again and save them. See
changes again and save them. See
for instructions.