Справочник Пользователя для Zebra 49834
292
170PAX4 Maintenance Manual
57518L-001 Rev. A
3/18/05
Preventive and Corrective Maintenance
Exterior Components—Door-Open Switch Replacement
Figure 164 • Removal and Installation of PCB Access Panel from Print Engine
6.
Partially pull the PCB access panel out.
7.
Follow the door-open switch cable out through the hole on the main frame and down to P2
on the main logic board.
on the main logic board.
8.
. Disconnect the cable from P2 on the main logic board.
Important •
Be careful when you pull the PCB access panel out, and make sure you don’t
loosen any cables.
Note •
The door-open switch cable is partially covered by heatshrink tubing near the
switch. The exposed green and yellow wires plug into main logic board connector P2.
PCB
Access
Panel
PCB Access
Panel Screws
(9)
PCB Access
Panel Screws
(9)
Right-Hand Model
Left-Hand Model
PCB
Access
Panel
Plastic Glide