Справочник Пользователя для Zebra 49834
Operations
Connect the Print Engine to a Power Source
57518L-001 Rev. A
3/18/05
170PAX4 Maintenance Manual
41
Connect the Print Engine to a Power Source
The power supply in the print engine automatically detects the applied line voltage and works
in the 90 to 264 VAC, 47 to 63 Hz range.
in the 90 to 264 VAC, 47 to 63 Hz range.
The AC power cord must have a three-prong female connector on one end that plugs into the
mating AC power connector at the rear of the print engine. If a power cable was not included
with your print engine, refer to
mating AC power connector at the rear of the print engine. If a power cable was not included
with your print engine, refer to
.
To connect the print engine to a power source, complete these steps:
1.
Turn the print engine power switch to the Off (O) position.
2.
Refer to
. Plug the power cord into the AC power connector on the rear of the
print engine.
3.
Plug the other end of the power cord into the power source.
Figure 17 • Power Connection
Caution • For personnel and equipment safety, always use an approved three-conductor
power cord specific to the region or country intended for installation. This cord must use
an IEC 320 female connector and the appropriate region-specific three-conductor
grounded plug configuration.
power cord specific to the region or country intended for installation. This cord must use
an IEC 320 female connector and the appropriate region-specific three-conductor
grounded plug configuration.
Left-Hand
Right-Hand
1
1
1
AC power connector