Справочник Пользователя для Zebra 49834
Preventive and Corrective Maintenance
Corrective Maintenance—Routine Referral Procedures (RRPs)
57518L-001 Rev. A
3/18/05
170PAX4 Maintenance Manual
153
Routine Referral Procedures (RRPs)
Routine Referral Procedures are commonly used steps that are performed often during
corrective maintenance. These procedures are referenced throughout this section of the
manual.
corrective maintenance. These procedures are referenced throughout this section of the
manual.
RRP No. 1: Remove and Open the 170PAX4 Print Engine
Remove the print engine from the applicator
1.
Turn Off (O) the print engine and disconnect the AC power cord and interface cables.
2.
Open the front cover, unlatch the printhead lever, and remove media and ribbon from the
print engine.
print engine.
3.
Close and latch the printhead lever, and then close the front cover.
4.
. Remove the four corner mounting screws securing the print engine to the
applicator.
5.
Loosen, but do not remove the center mounting bolt.
6.
To remove the print engine from the applicator, lift the print engine off the center
mounting bolt and place on a workbench.
mounting bolt and place on a workbench.
Caution • Turn OFF (O) the printer and disconnect it from the power source before
performing the following maintenance.
performing the following maintenance.
Note •
Retain all parts removed during disassembly, unless otherwise directed.
Note •
The keyhole and the center mounting bolt are designed to support the print engine
and assist in installing and removing the four mounting screws.