Справочник Пользователя для Crestron qm-rmcrx-ba

QuickMedia™ Receiver/Processor                      Crestron QM-RMCRX-BA  

NOTE:  When daisy-chaining Cresnet units, strip the ends of the wires carefully 
to avoid nicking the conductors. Twist together the ends of the wires that share a 
pin on the network connector, and tin the twisted connection. Apply solder only 
to the ends of the twisted wires. Avoid tinning too far up the wires or the end 
becomes brittle. Insert the tinned connection into the Cresnet connector and 
tighten the retaining screw. Repeat the procedure for the other three conductors. 

NOTE:  For additional information on video connections over CAT5, refer to 
the latest version of the Crestron CAT5 Wiring Reference Guide (Doc. 6137) 
which is available from Crestron website (http://www.crestron.com/manuals). 

NOTE:  For larger networks (i.e., greater than 28 network devices), it may be 
necessary to add a Cresnet Hub/Repeater (CNXHUB) to maintain signal quality 
throughout the network. Also, for networks with lengthy cable runs or varying 
types of network devices, it may be desirable to add a hub/repeater after only 20 
network devices.  

When connecting multiple QM devices, the route between a QM origination 
point (e.g., QM-TX) and a QM endpoint (e.g., QM-RMCRX-BA) cannot have 
more than two midpoints (e.g., QM-MD7x2 or other QM switchers). Refer to 
the following diagram when configuring a QM network. The aggregate length 
from transmitter to receiver cannot have a delay skew of more than 22 ns. 

NOTE:  Refer to Appendix B on page 65 for detailed auto-compensation 
information. 

The QM-RMCRX-BA can be mounted using the included four mounting 
brackets. Attach the included brackets using the existing cover screws located on 
the sides of the QM-RMCRX-BA as shown in the following diagram. 

• QuickMedia™ Receiver/Processor: QM-RMCRX-BA