Справочник Пользователя для INSTEON 2476d
INSTEON SwitchLinc V2 Dimmer User’s Guide
HOW TO SET UP SWITCHLINC DIMMER TO BE REMOTELY
CONTROLLED BY AN INSTEON CONTROLLER
CONTROLLED BY AN INSTEON CONTROLLER
Linking an INSTEON Controller to SwitchLinc Dimmer
To remotely control SwitchLinc Dimmer using another INSTEON Controller, follow these steps to link
SwitchLinc Dimmer and the INSTEON Controller together. Refer to your INSTEON Controller’s User’s
Guide for detailed instructions on how to properly install it and link it to SwitchLinc Dimmer. The following
will work for the most common INSTEON Controllers.
SwitchLinc Dimmer and the INSTEON Controller together. Refer to your INSTEON Controller’s User’s
Guide for detailed instructions on how to properly install it and link it to SwitchLinc Dimmer. The following
will work for the most common INSTEON Controllers.
1. Select your INSTEON Controller from the list below and follow the method shown to put it into
Linking Mode.
A. A Second SwitchLinc V2 Dimmer – Press and hold the Second SwitchLinc
Dimmer’s Paddle Top for 10 seconds, then release. To confirm that it is in
Linking Mode, the Second SwitchLinc Dimmer will flash the light that it is wired
to once and begin blinking the top LED in its LED Bar.
Linking Mode, the Second SwitchLinc Dimmer will flash the light that it is wired
to once and begin blinking the top LED in its LED Bar.
B. ControLinc
™ V2 Tabletop Controller – Choose the ON/OFF Button Pair you
want to use for controlling SwitchLinc Dimmer. Press and hold the ON Button
of the pair for 10 seconds. To confirm that it is in Linking Mode, ControLinc
V2’s Status LED will begin blinking.
of the pair for 10 seconds. To confirm that it is in Linking Mode, ControLinc
V2’s Status LED will begin blinking.
C. KeypadLinc
™ V2 – Choose the ON Button you want to use for controlling
SwitchLinc Dimmer. Press and hold the ON Button for 10 seconds. To
confirm that it is in Linking Mode, KeypadLinc V2 will flash the light that it is
wired to once and begin blinking the ON Button that you pushed.
confirm that it is in Linking Mode, KeypadLinc V2 will flash the light that it is
wired to once and begin blinking the ON Button that you pushed.
D. Other INSTEON Controllers – See the INSTEON Controller’s User’s Guide.
2. Press and hold the Paddle Top for 10 seconds on the SwitchLinc Dimmer
that is being controlled. To confirm linking, the SwitchLinc Dimmer will blink
the top LED in its LED Bar and flash the light that it is wired to. Depending
on the INSTEON Controller, you have about 4 minutes to perform this step
before Linking Mode times out automatically.
the top LED in its LED Bar and flash the light that it is wired to. Depending
on the INSTEON Controller, you have about 4 minutes to perform this step
before Linking Mode times out automatically.
Page 16 of 35