Справочник Пользователя для INSTEON 2476d

 

The Paddle Top makes your light go ON and the Paddle Bottom makes your light go OFF. 

•  Tap the Paddle Top to make your light go at the Local Ramp Rate from whatever brightness it 

currently has to the Local On-Level brightness. 

•  Tap the Paddle Bottom to make your light go at the Local Ramp Rate from whatever brightness it 

currently has to full-OFF. 

•  Double-tap the Paddle Top to make your light go full-ON quickly. 
•  Double-tap the Paddle Bottom to make your light go full-OFF quickly. 
•  Press and hold the Paddle Top to gradually brighten your light from whatever brightness it currently 

has to full-ON. 

•  Press and hold the Paddle Bottom to gradually dim your light from whatever brightness it currently 

has to full-OFF. 

 

Ramp to On-Level 

Fast ON 

Brighten 

Ramp to OFF 

Fast OFF 

Dim 

 

Pulling the SET Button at the bottom of the paddle out as far as it will go (about 1/8”) opens mechanical 
contacts that remove all power from SwitchLinc Dimmer and the load that it controls.  “Air gapping” can be 
useful for replacing bulbs or any other time you want the controlled circuit to be unpowered. 

Because SwitchLinc Dimmer’s settings are stored in non-volatile memory, setup information will not be 
lost when the unit unpowered. 

 

 
If you press the SET Button in too far when you undo the air gap, you might inadvertently reset
SwitchLinc V2 Dimmer to its factory default settings.  Just push the button in until its top is even with
the Trim Frame. 

Page 26 of 35