Справочник Пользователя для INSTEON 2444-422
2444-222, 2444-422, 2444-522 Rev. 2/24/2014 9:18 AM / See Owner’s Manual for Warranty Information.
Protected under U.S. and foreign patents (see www.insteon.com/patents)
© Copyright 2013 INSTEON, 16542 Millikan Ave., Irvine, CA 92606, 866-243-8022
Quick Start Guide
INSTEON
®
Micro Open/Close (Shutter)
Model: 2444-222/2444-422/2444-522
What’s Needed
•
Slotted #1 screwdriver
• Voltage meter
•
Philips screwdriver
• Wire cutter/stripper
Installing Micro Module
Installation should only be performed by a qualified electrician or a homeowner
who is familiar and comfortable with electrical circuitry. If you have questions,
consult an electrician or call the INSTEON Support Line at 866-243-8022
who is familiar and comfortable with electrical circuitry. If you have questions,
consult an electrician or call the INSTEON Support Line at 866-243-8022
1)
Write down the INSTEON ID found on the back of the unit (XX.XX.XX)
2)
Turn off breaker/fuse and verify that the power is off
3)
Disconnect wires from existing switch, fixture or outlet and prep all wires to
be connected to Micro module, with 3/16” (5mm) of bare wire on the ends
be connected to Micro module, with 3/16” (5mm) of bare wire on the ends
4)
Connect wires per diagram which corresponds to your installation
Note: sense lines carry very low current (~0.35mA 240V, ~0.17mA for 120V)
5)
After ensuring wires are firmly connected and that there is no exposed wire, turn on breaker/fuse
After a few seconds, Micro module LED will turn green
6)
Test by tapping Micro module up/down buttons
Motor will respond accordingly
Micro Module LED will turn green when motor is moving up/open and stay green until the down button is pressed
Micro Module LED will turn red when motor is moving down/closed and stay red until the up button is pressed
Micro Module LED will turn green when motor is moving up/open and stay green until the down button is pressed
Micro Module LED will turn red when motor is moving down/closed and stay red until the up button is pressed
7)
If installing a single momentary or dual momentary switch
a) Press and hold set button until it beeps
a) Press and hold set button until it beeps
LED will start blinking green
b) Press and hold set button until it beeps a second time
LED will start blinking red
Sense #2
(down - purple)
LED
Sense #1
(up - yellow)
Antenna
EU/AUS/NZ
North America
Down
Up
Down
Up
Down
Up
Down
Up