Справочник Пользователя для Insignia ns-l7htv-10atv

ENGLISH 09-0339

Charging the built-in battery 

Note: There is no standby mode for this TV, because it runs on a rechargeable battery.

Turn off your TV before charging the battery. Connect the supplied AC adapter. Charging starts, and the 

ON/CHG indicator is red. When the charging is completed, the indicator turns off.

Note: On initial use of the TV, charge the battery for 6 hours.

Step 5 Establish a signal

Make sure that the included rod antenna or a stronger HDTV antenna (not included) is attached to the input at the 
top of the TV. Extend the antenna rod and move the TV to a location where it can receive the strongest signal, free 
of obstructions and interference from other devices. Press 

TV on your remote control to ensure you are in TV mode.

Step 6 Scan for channels 

Note: See your User Guide for more information on connecting your TV 
directly to cable or satellite service and for scanning for radio stations.

To scan for channels when the TV signal source is Antenna 
Press 

MENU on the remote control, using the             buttons to 

highlight           (channel icon). The 

Channel menu opens. Press 

OK/ENTER or       to enter the Channel menu. Press the              buttons 
to select 

Auto Channel Search, then press OK/ENTER or        to enter 

the 

Auto Channel Search menu. Start to Scan is highlighted. Press 

OK/ENTER or       to start the scan.
If the Automatic Channel Search does not locate the channels you were expecting, try moving the TV to a location 
where you can pick up a stronger signal, then try rerunning the search. 

Step 3 Connect the AC adapter 

Connect the AC adapter into the DC IN jack on the right 
side of your unit, then connect the AC adapter to a 
100-240V power outlet.

© 2009 Best Buy Enterprise Services, Inc. All rights reserved. INSIGNIA is a trademark of Best Buy Enterprise Services, Inc. Registered in some countries. All other products and brand names are trademarks of their respective owners.

1

2

Note: The coin-shaped battery is already in the remote control. The first time you use the remote 
control, remove the plastic sheet from the bottom of the battery to activate the remote. 

Step 2 Install the remote control battery

Remove the battery holder from the back of the remote control by inserting a fingernail into the groove and 
pulling out the holder. Place a CR2025 battery with the + side up on the holder. Insert the holder into the 
remote control.