Справочник Пользователя для National Instruments NI CardBus-8310-to-PXI Expansion

© National Instruments Corporation

The following steps will guide you in completing the installation of your 
new NI CardBus-8310-to-PXI system.

It is highly recommended that Microsoft Windows users follow the 
software driver installation instructions exactly, in the order in which the 
instructions are presented in this chapter. If you do not follow the driver 
installation instructions, you will greatly increase your chances of failure 
while configuring your system.

The NI-CardBus-8310 driver is intended for use only with Windows 2000 and 

Windows XP.

You will be prompted to reboot after the software installation. Each shut down 

and reboot is important and is required for correct installation. If you shut down and reboot 
when requested, it may save you from having to make a call to NI technical support.

You must be logged in as a system administrator while installing the software. You must 
remain logged in as system administrator until installation is complete.

Under Windows XP, you must install the NI CardBus-8310 driver before 

connecting or inserting the hardware into the CardBus slot.

If you are using Windows XP, the “Found New Hardware” dialog box will only appear if 
you have Service Pack 2 installed. This dialog appears by default under Windows 2000.