Справочник Пользователя для NEC multisync xp29, xm29 xtra

1
2
3

12
13
14
15

4
5
6
7
8

11
10

9

Pin Assignments and Signal Levels for 15 pin RGB (Analog)

RED
GREEN or Sync on Green
BLUE
SDA
H. or Composite sync
V.SYNC
SCL
GND
GND
GND
GND
GND
GND
No  Connection
No  Connection

The REMOTE IN/OUT terminals allow you to control monitors by one remote

control.

NOTE:  The connection of three XP29 Xtra/XM29 Xtra monitors or more with

THROUGH OUT (VIDEO 1, VIDEO 2, RGB 1 or RGB 2) terminals may de-

grade image quality.

To do so:

1. Connect THROUGH OUT 1 BNC or S-VIDEO 1 OUT to external compo-

nents to relay the signal input at VIDEO 1 IN(BNC-type), or S-VIDEO 1 IN.

2. Connect the external component mono audio or stereo left channel audio

input to L AUDIO.

3. Connect the external component stereo right channel audio input to R AU-

DIO.

4. Set the 75

Ω

/HIGH impedance select switch of the corresponding input sig-

nal (BNC, S-VIDEO) on all but the last monitor to “HIGH” position. Only the

last monitor is set to “75

Ω

” position.

1. Connect THROUGH OUT 2 BNC or S-VIDEO 2 OUT to external component

to relay the signal input at VIDEO 2 IN(BNC-type) or S-VIDEO 2 IN.

2. Connect the external component mono audio or stereo left channel audio

input to L AUDIO.

3. Connect the external component stereo right channel audio input to R AU-

DIO.

4. Set the 75

Ω

/HIGH impedance select switch of the corresponding input signal

(BNC, S-VIDEO) on all but the last monitor to “HIGH” position. Only the last

monitor is set to the “75

Ω

” position.

5. Connect the REMOTE OUT of the monitor to the REMOTE IN of the next

monitor using the optional remote cable.

THROUGH OUT Connections

1. (RGB1): Connect Mini D-Sub 15-pin THROUGH OUT to an RGB input con-

nector of other monitors.

(RGB2): Connect the R.G.B.H and V THROUGH OUT terminals to relay the

signal input at the R.G.B.H and V IN terminals.

2. Set all the 75

Ω

/HIGH impedance select switches on all but the last monitor to

“HIGH” position. Only the last monitor is set to the “75

Ω

” position.

3. Connect the REMOTE IN of the monitor to the REMOTE OUT of the next

monitor using the optional remote cable.

NOTE: ''Plug and Play'' is available only for the monitor connected directly

to a personal computer with the MIni D-Sub 15-pin RGB connector. There-

fore, ''Plug and Play'' does not work for monitors connected with the

THROUGH OUT terminal. This is because only the RGB video, the hori-

zontal, and the vertical sync. signal is output from the THROUGH OUT

terminals.

NOTE: ''Plug and Play'' is not available for the RGB 2 BNC terminals.