Справочник Пользователя для Crestron ug cls-c6 cls-c6m clsi-c6 clsi-c6m
iLux
™
Lighting System
Crestron CLS/CLSI-C6 & CLS/CLSI-C6M
7. If you would like a certain shade group to be unaffected by that scene recall,
press and hold the center of the button (so both side make contact) for three
seconds. The top two and the bottom two LEDs of the associated bargraph
will be lit (and the display will show - - ) to indicate that the level of that
shade group will not change when the scene is recalled.
seconds. The top two and the bottom two LEDs of the associated bargraph
will be lit (and the display will show - - ) to indicate that the level of that
shade group will not change when the scene is recalled.
8. To adjust the fade time, press the ^ and v buttons. When going up, the value
will go from 0 seconds to 59 seconds, and then 1 minute to 99 minutes.
When going down, the value will go from 99 minutes to 1 minute, and then
59 seconds to 0 seconds. The Min and Sec LEDs light as appropriate.
Adjustment to fade time can be made when either Lights mode or Shades
mode is active.
When going down, the value will go from 99 minutes to 1 minute, and then
59 seconds to 0 seconds. The Min and Sec LEDs light as appropriate.
Adjustment to fade time can be made when either Lights mode or Shades
mode is active.
9. When all the lighting loads are at the desired level and shades are at the
desired position, press Save to save these settings as the new preset for that
scene. If you make a mistake while changing a setting, press Cancel to
discard changes and return to Standard mode before pressing Save.
scene. If you make a mistake while changing a setting, press Cancel to
discard changes and return to Standard mode before pressing Save.
10. Repeat the above procedures for all scenes that require changes.
Problem Solving
Troubleshooting
The table below provides corrective action for possible trouble situations. If further
assistance is required, please contact your dealer.
assistance is required, please contact your dealer.
CLS-C6 Troubleshooting
TROUBLE
POSSIBLE CAUSE(S)
CORRECTIVE ACTION
The unit does not
respond as
expected after
changing preset.
respond as
expected after
changing preset.
Incorrect procedures were
used to change the
preset.
used to change the
preset.
Refer to “Changing Scene
Presets” on page 5 to revise the
preset correctly.
Presets” on page 5 to revise the
preset correctly.
Further Inquiries
If you cannot locate specific information or have questions after reviewing this
guide, contact your dealer.
guide, contact your dealer.
Crestron Electronics, Inc.
User Guide - DOC. 6395A
15 Volvo Drive Rockleigh, NJ 07647 (2014521)
Tel: 888.CRESTRON
Tel: 888.CRESTRON
12.05
Fax: 201.767.7576
Specifications subject to
www.crestron.com
change without notice.