Справочник Пользователя для jetway nf18gfr3a

Chapter 2

Hardware installation

2-1 Hardware installation Steps

Before using your computer, you had better complete the following steps:
1.  Check motherboard setting
2.  Install CPU
3.  Install Memory
4.  Install Expansion cards
5.  Connect Ribbon cables, Panel wires, and power supply
6.  Setup BIOS
7.  Install software driver & utility

2-2 Checking Motherboard’s Jumper Setting

(1) Keyboard Power On function Enabled/Disabled: JP1

USB Wake-Up function Enabled/Disabled :JP3

When setting Enabled you can using keyboard by key in password or use USB device
to power on system.

JP3 2-3 closed USB Wake-Up Enabled

JP1 2-3 closed K/B Power ON Enabled

JP3 1-2 closed USB Wake-Up Disabled (Default)

JP1 1-2 closed K/B Power ON Disabled (Default)

JP1

JP3

(2) CPU Front Side Bus Frequency Setting (4-pin) : JP4

CPU Front Side Bus Frequency Setting

1-2 : 133/166MHz

(AUTO)

JP4

2-3 : 166MHz

JP4

3-4 : 100MHz

JP4

OFF : 133MHz

JP4

Note: CPU Front Side Bus Frequency also can change setting in BIOS SETUP, please

refer

page 33

Miscellaneous Control in Host Clock at Next.

Note: When overclocking cause system can not boot up, users have to keeping press the

“INS” key and push the power on button to switch on the system until the screen
have display to recovery the standard Default. Otherwise the CMOS will keep the
faulty data and M/B will not function.

Note: After overclocking fail BIOS will auto load safety Default, users have to load

“Standard Defaults” or “Optimized Defaults” again for normal using.