Справочник Пользователя для iskratel si2000 callisto821 router
SI2000 Callisto821+ Router Users Guide
8/107
2 GETTING STARTED
2.1 Installation of hardware
2.1.1 Ports
The following figure shows the rear panel of your SI2000 Callisto821+ Router.
WAN
This port is used for connecting the ADSL cable to your phone jack. Connect the SI2000 Callisto821+ Router
to the ADSL port to access the Internet.
to the ADSL port to access the Internet.
RES (Reset button)
This button is used to reset the configuration of the router to factory default values. You must hold this button
while the router is starting-up until ALM led will start flashing fast (about 30 seconds). Callisto821+ will use
factory default settings only for the time it is running. If you want to preserve factory default settings save the
configuration.
while the router is starting-up until ALM led will start flashing fast (about 30 seconds). Callisto821+ will use
factory default settings only for the time it is running. If you want to preserve factory default settings save the
configuration.
Ethernet 10Base-T/100Base-T port
Use a straight-through or crossover ethernet cable (
) to connect your SI2000
Callisto821+ Router to a computer or any other device. It is possible to manage the settings of the router with
telnet connection using this port. The factory setting for IP address is 192.168.1.1.
telnet connection using this port. The factory setting for IP address is 192.168.1.1.
Figure 2: The rear panel of the SI2000 Callisto821+ Router