Справочник Пользователя для MINOURA pair stand

!

!

2

3

Please read this instuctions carefully before use.

Thank you for purchasing Minoura PAIR STAND bike display stand.

This stand can hold up to two bikes horizontally in a space as same as for only one bike.

This stand is designed for standard two wheel bicycles.

Do not use this stand for electric bikes or tandems. The weight

limit for two bikes is 30 kgs. or 66 lbs.

Make sure the stand is used on a level floor.

Failing to set-up and use this stand on a level floor may cause the

stand to fall over and cause damage or injury.

This stand requires some

assembly. You will need a M4

Hex wrench and a 13 mm

spanner in order to assemble

the PAIR STAND completely.

1

Screw the foot adjuster to the nut located on each leg

end.

Insert four M8x55 bolts into the holes on the bottom of

the Lower Pillar, then put through the legs. The long leg

is for rear section, and the short legs are for front sec-

tion. Be sure to fit the legs to the shape of the horrow of

the bottom plate.

(Fig. A)

(Fig. B)

(Fig.C)

Install the Reinforcement Arms between the Lower Pillar and

the Front Legs by tightening the M6x14 bolts for the pillar

side, and M6x30 bolts for the leg side.  After installing the

Reinforcement Arms, tighten the M8x55 bolts firmly. Wrong

step may make you unable to install the Reinforcement Arms.