Справочник Пользователя для MINOURA workman pro

Wheel Truing Stand

WORKMAN PRO

Instruction Manual

Thnak you for your purchasing Minoura “Workman

Pro” truing stand.

This Workman Pro is a wheel truing stand for stan-

dard bicycle with unique Auto-Centering system that

allows you to do almost every procedure such as

building or adjusting your bicycle wheel without any

tool such as a wheel centering gauge basically.

The frame is foldable for your easy storage and trans-

portation.

Please read this instruction manual carefully before

use and we hope you  grow up your skills of the bi-

cycle wheel.

A wheel truing stand is a utensil to measure the bal-

ance of the wheel.  Do not use Workman Pro as a

This Workman Pro has a special method, auto-cen-

tering system, so you can finish building or checking

a wheel with only this truing stand basically. But we

suggest you to use a wheel centering gauge for your

complete wheel adjustment.

Both right and left arms are connected so they will

move together at the same time.  When you open or

close the arms, you should hold both arms with your

both hands.

The arms have hollow on its top to hold the wheel

hub shaft.

When you install a wheel on the Workman Pro, fol-

low these processes.

At first, open the arms enough to install the wheel

hub shaft, and push down the wheel into the hollow

of the arms, then fix the quick release lever or tighten

the hub nut slightly.

The gauge plate for vertical shaking is located in the

center of the U-shaped gauge frame, and it has two

purposes.

One is to measure the vertical shaking of the wheel,

and another one is to help adjustment for wheel cen-

tering process.

When you want measure the vertical shaking of the

wheel, put the U-shaped gauge frame close to the rim.

And put the gauge plate close to the rim surface with

rotating the knob bolts.  The knob bolt has 0.1mm

level scales in its own surface.  Do NOT touch the tip

of the gauge plate to the rim, otherwise your later pro-

cedure may be difficult.