Справочник Пользователя для Lumiscope 1145

8

all the batteries at the same time - it is dangerous to 
mix old and new batteries. Contact your local waste 
disposal authority for instructions on how to dispose 
of used batteries. Used batteries can be harmful to 
the environment, and should not be thrown out with 
household trash.

Setting Date, Time And Measurement Units
It is important to set the clock before using your blood 
pressure monitor, so that a time stamp can be assigned 
to each record that is stored in the memory.

1.  When the unit is off, press and hold SET for 2 seconds 

to enter the setting mode.

2.  The setting order is as follows: 12/24 hour format, 

hour, minute, year, month/day or day / month format, 

month, date, and measurement unit (kPa or mmHg).

3.  Press 

 or 

 to increase / decrease a value or 

change the setting.

4.  Press SET to accept the change and switch to the 

next setting.

5.  When you are finished, press   to exit the setup 

menu.

Positioning The Wrist Cuff

It is important to properly position the wrist cuff to 
ensure that you receive an accurate reading.
1.  Remove all accessories (watch, bracelet, etc.) from 

your left wrist. If your physician has diagnosed you 

with poor circulation in your left arm, use your right 

wrist.

2.  Roll or push up your sleeve to expose the skin.
3.  Apply the cuff to your left wrist with your palm facing 

up.

4.  Position the edge of the cuff about 0.4 inches (1cm) 

from the bottom of your palm.

5.  Fasten the wrist cuff around your wrist, leaving no 

extra room between the cuff and your skin. If the cuff 

is too loose, the measurement will not be accurate.