Справочник Пользователя для Belinea 2225 s1w

Belinea 2225 S1W 

- 

Operating Instructions - 

Belinea monitors are designed to be environmentally 

sound according to TCO guidelines. Please direct any

questions you may have regarding the disposal of your 

monitor to our European waste management affiliates:

www.belinea.com/service/recycling

This manual will familiarize you with the installation and 

use of your Belinea monitor. Please take the time to 

look through these instructions even if you are familiar 

with monitors. 
We have taken all possible care to ensure that this 

manual contains correct, accurate information. However, 

the manufacturer cannot assume liability for any possible 

errors. In addition, the manufacturer cannot guarantee 

that the hardware will meet the purpose you require. We 

would appreciate reports of any errors, suggestions or 

criticism.

© Copyright 2006 

MAXDATA Systeme GmbH 

45768 Marl, Germany 

www.maxdata.com

Editing, DTP and translation by think global GmbH,  

www.think-global.com.
All rights reserved. No part of this manual may be repro-

duced, processed or distributed in any form (print, pho-

tocopy, microfilm or any other process) or processed by

an electronic system without prior written permission 

from the manufacturer. 
We reserve the right to make changes according to 

technical progress. Belinea is an internationally regis-

tered trademark. Other brand names may be registered

trademarks and must be treated as such.  

INTRODUCTION ......................................................... 2

IMPORTANT INFORMATION ..................................... 3

CARING FOR yOUR LCD MONITOR ........................ 3

WALL MOUNTING ...................................................... 3

UNPACkING ............................................................... 4

CONNECTING ............................................................ 4

STARTUP .................................................................... 4

CONFIGURATION ...................................................... 5

BASIC SETUP ............................................................ 5

IMAGE SETTINGS USING THE OSD MENU ............ 5

OSD MENU FUNCTIONS ........................................... 6

TROUBLESHOOTING ................................................ 7

TECHNICAL SPECIFICATIONS ................................. 7

DEFINITION OF THE MAxDATA WARRANTy ......... 8

The symbols below are used in this manual to indicate 

where there is risk of injury or damaging devices or to

indicate especially useful information:

DANGER! Indicates risk of injury. When not fol-

lowing instructions, severe injury or death may

result.
ATTENTION!  Indicates  possible  damage  to

devices. When not following instructions, devices 

may be heavily damaged.
IMPORTANT! Indicates hints on operation and

other useful information.

We are all responsible for the environment: this manual was printed from front to back on paper 

that was produced without chlorine.

Some Belinea monitor models come with 2 power cords. 

Please ensure you use the UK plug (3 pin) in the UK and

not the European plug (2 pin).
Do not place the monitor in very hot or cold, nor damp or 

dusty surroundings. Do not put vases etc. on the monitor, 

water may cause short circuits. Do not block or cover the 

ventilating openings. Do not install this monitor in areas 

where too much light or sunshine might directly hit the 

screen, otherwise the brightness of the picture will be 

poor due to reflections. Refer all servicing and mainte-

nance to authorised service personnel only!

CAUTION 

Do not remove the cover! 

Serious electrical shock hazards exist inside 

this monitor.
NOTE 

Removal of cover invalidates your warranty.