Справочник Пользователя для husky-liners 54201

                                                                           

5420_Installation Ins#F7A06.doc

Rev: 0

Tools Required
• 

1/8” drill bit / Drill

• 

Center punch / Hammer

• 

Short Phillips screwdriver or drill attachment

• 

Driver & passenger side rear mud guard

• 

#10 screw (8)

• 

Washers (8)

• 

U-clip (8)

• 

Instruction sheet

 NOTE:  It may be necessary to remove the wheels depending on the tools being used for installation.

1.  Remove existing fastener and u-clip from location A and plastic fastener from location C (Figure 1).
2.  Install mud guard to rear fender at location A using provided u-clip, washer and #10 screw (Figure 1).  Check fit and parallel

and adjust accordingly before tightening.

3.  Install a u-clip, washer and #10 screw at location C.
4.  Using mud guard as a template, mark and drill 1/8” holes at locations B and D.
5.  Install #10 screw and washer at location D, thru mud guard, fender liner and into a U-clip placed on the backside of fender

liner (figure 2).

6.  Install #10 screw and washer at location B, thru mud guard, fender and into a U-clip placed on the backside of fender.