Справочник Пользователя для opcode studio 4

and the Prophet 2000) that communicate 
using non-MIDI transfer rates. To use 
Sound Designer II with these samplers, 
you must use a standard MIDI interface. 
Either:

•

1.Connect a standard MIDI interface 
to an unused Macintosh serial port, 
or

•

2.Connect a standard MIDI interface 
to one of the Studio 4’s THRU ports, 
then use the front panel THRU switch 
whenever you need to send data 
between Sound Designer II and a 
non-standard sampler.

You can’t send system exclusive data to a 
virtual instrument consisting of two or 
more MIDI channels from the same 
device, or the sysex data will be sent 
incorrectly (If you think about the situa-
tion, you wouldn’t want to do this, 
anyway).

Reduce the Studio 4->Macintosh commu-
nication speed if you’re having difficulty 
receiving large System Exclusive data 
dumps. Reduce the speed in small incre-
ments until the data is received properly.

This problem is unlikely to occur unless 
you have disabled the reporting of over-
run errors since lost data is reported as an 
overrun error.

If you experience a crash when running 
the installer and are using the Virex INIT 
for virus protection, open the Control 
Panel and select Virex’s panel. From the 
pop-up menu, select File Diagnosing 
Options. Deselect Diagnose Files when 
Opened and Check for HyperCard 
Virus. Run the Installer again, and the 
Macintosh should not crash. If problems 
persist, completely remove any Virus 
checking INITs from your System folder 
(Extensions folder for System 7), restart 
your Macintosh, and run the Installer 
again.