Справочник Пользователя для morley-pedals pwonew

Please take a few minutes to familiarize 
yourself with the features of your new pedal. 
With common sense handling, it should last for 
years. We know you will appreciate the rugged 
construction of your Morley®. Most of all, we 
hope you enjoy using it as much as we enjoyed 
building it. 

The Wah Mode is activated by pushing the 
Wah switch. The Power Wah is equipped with 
true bypass. This means that when the pedal is 
in bypass mode, your original guitar signal is 
uninterrupted. We’ve maintained the full, thick 
sound and wide bandwidth of previous Morley 
WAH pedals and added more reactive sound. 
Now you can make your guitar talk and sing 
similar to the sounds of Hendrix, Clapton and 
other wah wah masters. 
 

9V: Use Morley’s 9 VDC 300 milliamp 
regulated adapter only. 
IN:  Input jack. Plug instrument into this jack 
using 1/4” guitar cable. 
OUT: Connect amplifier to this jack using a 
1/4” guitar cable. 
NOTE: You’ll find cords fit very tightly into 
our input and output jacks. The tight fit helps 
prevent the cord from becoming accidentally 
unplugged from the pedal. Make sure the cords 
are completely plugged in for best results. 

Use Morley’s 9VDC 300 milliamp regulated 
adapter only. Using a non-regulated adapter 
could cause a low frequency hum in your 
amplifier and may damage the pedal. 

The PWO is designed to use one 9 volt battery 
when not using an adapter. We suggest you use 
a good quality alkaline battery. 
 
To prolong battery life, unplug your cord 
completely from the input jack when not using 
the pedal. When the pedal is not used for 
extended periods, we recommend you remove 
the battery from the pedal or replace it every 
six months to prevent leakage problems.  

When the battery becomes weak, the overall 
wah will become weak and your signal may 
become slightly distorted.  
Remove the battery door located on the bottom 
of the pedal (a short cord is attached to the 
door to help prevent loss). Once the door is off, 
the old battery can be removed from the battery 
snap and a new battery plugged in. Make sure 
the polarity (+/-) is correct before inserting the 
new battery. 
When you replace the battery door, you will 
notice it fits very tightly against the battery. 
This prevents the battery from rattling inside 
the pedal. 

All Morley® pedals are warranted for two 
years from date of purchase. To obtain 
warranty service contact the store where 
purchased. 
 
 

POWER: 9 Volt Battery or 9VDC 300 
milliamp regulated adapter (center pin is 
negative) 
CURRENT DRAW: 5 mA @ 9 VDC 
WEIGHT: 2.9 lb./ 1.32 kg 
 
 
 
Here is a general recommendation for 
hooking up a WAH with other effects: 

•