Справочник Пользователя для kvh 01027702bk install
6. At each of the eight mounting holes in the roof,
follow the steps below to install a jack nut.
a. Insert the supplied
1
⁄
4
"-20 x 1" hex head bolt
into a friction wrench, using the large hole
marked “6&8JN.” Be sure to insert the bolt
into the correct side of the wrench (marked
“Enter Screw This Side”). Four friction
wrenches are provided in the kitpack.
marked “6&8JN.” Be sure to insert the bolt
into the correct side of the wrench (marked
“Enter Screw This Side”). Four friction
wrenches are provided in the kitpack.
Friction Wrench
b. Screw the bolt into a jack nut.
Screwing the Bolt into a Jack Nut
c. Apply silicone sealant or RTV along the
edges of the mounting hole in the roof.
d. Insert the jack nut into the mounting hole.
e. While holding the friction wrench in place,
tighten the bolt with a
7
⁄
16
" nut driver or socket.
This forces the side tabs of the jack nut to
compress against the underside of the roof. Do
not use an air wrench – it might strip the jack
nut.
compress against the underside of the roof. Do
not use an air wrench – it might strip the jack
nut.
4
Jack Nut
If the vehicle’s roof has a thick vinyl
covering, trim the vinyl around each
mounting hole to allow the head of
the jack nut to fully contact the
metal roof.
covering, trim the vinyl around each
mounting hole to allow the head of
the jack nut to fully contact the
metal roof.