Справочник Пользователя для morley-pedals pwa

 

Please take a few minutes to familiarize yourself 
with the features of your new pedal. With common 
sense handling, it should last for years. We know 
you will appreciate the rugged construction of your 
Morley®. Most of all, we hope you enjoy using it as 
much as we enjoyed building it.

 

 

The Wah Mode is activated by pushing the Wah 
switch (a red LED, located above the WAH switch, 
will light when it’s “on”). With this new series, 
we’ve maintained the full, thick sound and wide 
bandwidth of previous Morley WAH pedals and 
added more reactive sound. Now you can make your 
guitar talk and sing similar to the sounds of 
Hendrix, Clapton and other greats of the 60’s and 
early 70’s. See WAH level for suggested settings or 
experiment to create your own sound.

 

 

9V: Use Morley’s 9 VDC 300 milliamp regulated 
adapter only. 
IN:  Input jack. Plug instrument into this jack using 
1/4” guitar cable. 
OUT: Connect amplifier to this jack using a 1/4” 
guitar cable. 

NOTE: You’ll find cords fit very tightly into our 
input and output jacks. The tight fit helps prevent 
the cord from becoming accidentally unplugged 
from the pedal. Make sure the cords are completely 
plugged in for best results.

Use Morley’s 9VDC 300 milliamp regulated 
adapter only. Using a non-regulated adapter could 
cause a low frequency hum in your amplifier and 
may damage the pedal.

 

The PWA is designed to use one 9 volt battery when 
not using an adapter. We suggest you use a good 
quality alkaline battery. 
 
To prolong battery life, unplug your cord 
completely from the input jack when not using the 
pedal. When the pedal is not used for extended 
periods, we recommend you remove the battery 
from the pedal or replace it every six months to 
prevent leakage problems.

  

When the battery becomes weak, the overall wah 
will become weak and your signal may become 
slightly distorted.  
Remove the battery door located on the bottom of 
the pedal (a short cord is attached to the door to 
help prevent loss). Once the door is off, the old 
battery can be removed from the battery snap and a 
new battery plugged in. Make sure the polarity (+/-) 
is correct before inserting the new battery. 
When you replace the battery door , you will notice 
it fits very tightly against the battery. This prevents 
the battery from rattling inside the pedal.

 

All Morley® pedals are warranted for two years 
from date of purchase. To obtain warranty service 
contact the store where purchased, or call 1-800-
284-5172.

 

POWER: 9 Volt Battery or 9VDC 300 milliamp 
regulated adapter (center pin is negative) 
CURRENT DRAW: 5 mA @ 9 VDC 
WEIGHT: 2.9 lb./ 1.32 kg 
INDICATOR: Wah mode LED on 
                       Bypass mode LED off

 

•