Справочник Пользователя для Intel HS-2601A

 

51

 

On-Chip Primary/Secondary PCI IDE: 

The integrated peripheral controller contains an IDE interface that 

supports a single IDE channels. Select Enabled to activate the 

channel. 

 

USB Keyboard Support:  

Select Enabled if your system contains a Universal Serial Bus 

(USB) controller and you have a USB keyboard. The available 
choices are Enabled, Disabled. 

 

This item allows you to decide to active whether PCI Slot or 

on-chip VGA first The available choices are PCI Slot, Onboard . 

 

KBC Input Clock: 

The input clock setting of your onboard keyboard controller is set 

from here. 

 

Onboard FDC Controller:  

Select Enabled if your system has a floppy disk controller (FDC) 

installed on the system board and you wish to use it.  If you install 

and-in FDC or the system has no floppy drive, select Disabled in 
this field. The available choices are Enabled, Disabled. 

 

Onboard Serial Port 1/2: 

This item allows you to determine access onboard serial port 1/2 
controller with which I/O address. The available choices are 

3F8/IRQ4, 2F8/IRQ3, 3E8/IRQ4, 2F8/IRQ3, Disabled, Auto. 

 

UART Mode Select: 

This option allows you to configure the infrared interface modes 
(IrDA, ASKIR (an IrDA-compliant serial infrared) port, and 

Normal) generated from the second serial port. Only when set to 
ASKIR mode will the options RxD. TxD Active and IR 

Transmission delay activate for configuration. Disabling the 

Onboard Serial Port 2 setting automatically removes the UART 
Mode Select option from the options list.  

 

UART2 Duplex mode:  

Select the value required by the IR device connected to the IR 
port. Full-duplex mode permits simultaneous two-direction 

transmission. Half-duplex mode permits transmission in one 
direction only at a time. The available choices are Half, Full. 

 

RxD, TxD Active:  

This item allows you to determine the active of RxD, TxD. The 

available choices are “Hi, Hi”, “Lo, Lo”, “Lo, Hi”, “Hi, Lo”.