Руководство По Работе для Panasonic MCUL674
CAUTION:
Do not use attachments if they are wet.
A
ttachments used in dirty areas, such as under a refrigerator,
should not be used on other surfaces until they are washed. They could leave marks.
To return the handle to the storage position when the vacuum cleaner is not
in use, press handle release button and push the handle down for easy
storage.
in use, press handle release button and push the handle down for easy
storage.
NOTE: You should hear a noticeable “click” sound when handle reaches the
storage position.
storage position.
MAINTENANCE AND SERVICING
A) VACUUM CLEANER STORAGE
Handle
Release
Button
Release
Button
Operating
Position
Position
Storage
Position
Position
Always follow all safety precautions when cleaning and servicing the vacuum cleaner.
WARNING: Electrical Shock And Personal Injury Hazard
Disconnect from electrical supply before servicing or cleaning the vacuum cleaner. Failure to do so could result in elec-
trical shock or personal injury from vacuum cleaner suddenly starting.
trical shock or personal injury from vacuum cleaner suddenly starting.
B) CLEANING EXTERIOR AND ACCESSORIES
Disconnect mains plug from wall outlet.
Clean exterior using a clean, soft cloth that has been dipped in a solution of mild liquid detergent and water, then wrung dry. Wipe
dry after cleaning. DO NOT drip water on vacuum cleaner.
dry after cleaning. DO NOT drip water on vacuum cleaner.
Wash attachments in warm soapy water, rinse and air dry. Do not clean in dishwasher.
DO NOT use accessories if they are wet.
- 8 -
- 13 -
Motor
Shaft
Belt
Pulley
1
4
End
Cap
Base
Slot
Agitator
Nozzle
Base
1
5
TO REPLACE BELT
Seat right end of agitator into nozzle base. To seat agitator
end, place rounded portion of agitator end cap down into slot
in nozzle base.
end, place rounded portion of agitator end cap down into slot
in nozzle base.
Loop the new belt on the belt pulley.
Loop the other end of belt onto the motor shaft on the left
end of agitator.
end of agitator.
Pull left end of agitator forward and seat the end cap into
nozzle base.
nozzle base.
Belt
Agitator
1
6
Press firmly, checking to see that each end is completely
inserted.
inserted.
Check to see that the belt is centered on the belt pulley and
that the agitator turns freely.
that the agitator turns freely.
Lower Plate
Nozzle Cover
Retainer
1
7
Make sure the nozzle cover retainers are in the UNLOCK
position. Hook the front of the nozzle cover on to the nozzle
base and rotate downward. Once in place, rotate the nozzle
cover retainers to the LOCK position.
position. Hook the front of the nozzle cover on to the nozzle
base and rotate downward. Once in place, rotate the nozzle
cover retainers to the LOCK position.