Руководство По Работе для Panasonic SC-HT07

Скачать
Страница из 32
5
RQT7
38
0
Spea
ker
 se
tup (for 
SC
-H
T07
)
Setup
3
1
2
Adjust the speaker height.
e.g., With the stand attached 
to the lower rear of the 
speaker
Loosen the attached speaker mounting plate screw until the 
attached speaker is slightly loose and adjustable.
• Be careful not to loosen the screw too much or the speaker may 
detach and fall.
Adjust the position of the pipe. 
• After adjusting the height, tighten the screw on the mounting plate 
securely.
Stopper screw
Screw to stop mounting 
plate from moving or 
sliding below this point.
4
1
2
Connect the speaker cables.
Connect the speaker cables.
Press the speaker cable into the groove.
If there is any excess cable, thread it from the opening near the top of
the pipe while pulling it from the bottom of the base.
Copper
Silver
5
1
2
Fasten the speaker cable to the base.
Press the speaker cable and thread between the hooks.
Fit the speaker cable into the base cover groove as far as 
possible.
Wall
Preventing the speakers from falling over
Attach screw eyes (not included) to secure the speakers to a wall
(diagram on the right).
• Obtain the screws appropriate to the walls and pillars to which the they 
are going to be fastened.
• Consult with a qualified housing contractor concerning the appropriate 
procedure when attaching to a concrete wall or a surface that may not 
have strong enough support. Improper installation may result in 
damage to the wall or speakers.
(x 8)
(x 8)
(x 4)
(x 4)
Supplied 
accessories
Speaker stands
Stand bases
Screws (large and small)
SC-HT07PP-EN.fm  Page 5  Friday, May 7, 2004  3:41 PM