Руководство По Работе для Panasonic TH-50PZ80E
Problem
Actions
Chaotic image, noisy
•
Set “P-NR” in the Picture Menu (to remove noise). (p. 24)
•
Check nearby electrical products
(car, motorcycle, fl uorescent lamp).
(car, motorcycle, fl uorescent lamp).
No image can be
displayed
displayed
•
Is “Colour” or “Contrast” in the Picture Menu set to the minimum?
(p. 24)
(p. 24)
•
Check Colour System. (p. 31)
Blurry or distorted image
(no sound or low volume)
•
Reset programme. (p. 31)
Unusual image is displayed
•
Turn off the TV with Mains power On / Off switch, then turn it On
again.
again.
No sound is produced
•
Is “Sound mute” active? (p. 9)
•
Is the volume set to the minimum?
Sound level is low
or sound is distorted
or sound is distorted
•
Sound signal reception may be deteriorated.
•
Set “MPX” (p. 24) in the Sound Menu to “Mono”. (Analogue only)
Whirling sound is heard
•
The sound is from built-in cooling fan
(not a sign of faulty operation).
(not a sign of faulty operation).
•
Due to the digital reception technologies involved, quality of the DTV signals may be relatively low in some
cases, despite good reception of analogue programmes.
cases, despite good reception of analogue programmes.
Unable to receive signals
with a high-performance
aerial
with a high-performance
aerial
•
Install an aerial individually for the TV and VCR
(or use a splitter).
(or use a splitter).
TV
VCR
Aerial
Input
terminal
Input
terminal
Aerial Output
Aerial Output
Aerial Input
(Individual aerial)
(Individual aerial)
Splitter
Interference or
frozen / disappearing
image in DVB
frozen / disappearing
image in DVB
•
Check “DVB Signal Condition”. (p. 31)
If “Signal Quality” or “Signal Strength” are displayed in red, check
aerial.
If problem persists, consult your local Panasonic dealer.
If “Signal Quality” or “Signal Strength” are displayed in red, check
aerial.
If problem persists, consult your local Panasonic dealer.
•
Turn the TV off with the Mains power On / Off switch, then turn it
On again.
On again.
Sound is unusual
•
Set the sound setting of the connected equipment to
“2ch L.PCM”.
“2ch L.PCM”.
•
Check the “HDMI1 / 3 Input” setting in the Sound Menu. (p. 24)
•
If digital sound connection has a problem, select analogue sound
connection. (p. 46)
connection. (p. 46)
Pictures from external
equipment are unusual
when the equipment is
connected via HDMI
equipment are unusual
when the equipment is
connected via HDMI
•
Is the HDMI cable connected properly? (p. 44)
•
Turn Off the TV and equipment, then turn them On again.
•
Check an input signal from the equipment. (p. 48)
•
Use an equipment compliant with EIA/CEA-861/861B.
TV goes into
“Standby mode”
“Standby mode”
•
Off Timer function is activated.
•
The TV enters “Standby mode” about 30 mins. after analogue
broadcasting ends.
broadcasting ends.
The remote control
does not work
does not work
•
Are the batteries installed correctly? (p. 6)
•
Has the TV been switched On?
50
FAQs
Screen
Sound
HDMI
Other
DVB