Инструкция для Panasonic KX-PS8000

Close the windows of the applications and
turn off the computer, then turn it on
again.

The transfer data area for printing
has allocated more than 16MB.

Memory is allocated
Above 16MB. If your
SCSI controller is
connected in an ISA slot,
Printing may not print
correctly!!

Check the cable connection of the system
or turn on the printer.

KX-PS8000 is not recognized as a
SCSI device.

KX-PS8000 is not
detected. Selected port is
SCSI. Please check SCSI
cable, Power ON or
Printer condition

B

Confirm the SCSI board is correctly
installed in the computer or cable is
correctly connected.

B

Turn off the computer, then turn it on
again.

An illegal error has occurred.

KX-PS8000 or Printer
Driver is illegal condition.
Abort printing.

Reinstall the KX-PS8000 software.

1/16 compression table is not
found.

Check the cable connection of the printer
or turn on the printer.

The printer connected with the
parallel cable is not recognized.

Block 16 table open error:
Table file not open!

B

Reprint later when the printer is free
from other jobs.

The printer is printing.

KX-PS8000 is not
detected. Selected port is
LPT. Please check LPT
cable, Power ON or
Printer condition.

LPT Port or KX-PS8000
is busy.

The printer is being used by another
device.

KX-PS8000 already is
used by other devices.

B

Reprint later when the printer is free
from other jobs.

B

Turn off the system (scanner / printer /
computer), then turn it on again.

ASPI does not support
this mode!!

SCSI board and its driver are not
installed correctly.

Correctly install the SCSI board and its
driver. (Refer to the instructions manual of
the SCSI board.)
For any other trouble related to SCSI,
refer to the SCSI section of
Troubleshooting 

ASPI is not initialized!!