Инструкция для Panasonic KX-PS8000
145
Error message
Possible cause
Recovery
Troubleshooting
Not Detect.
Turn off the system (scanner / printer /
computer), then turn it on again. If the
trouble still remains, confirm the following
points.
computer), then turn it on again. If the
trouble still remains, confirm the following
points.
B
The terminator is correctly set.
B
The SCSI board is correctly installed in
the computer.
the computer.
B
The system is correctly connected with
SCSI cables.
SCSI cables.
B
Each SCSI device has a different ID
Number.
For any other trouble related to SCSI,
refer to the SCSI section of
Troubleshooting
Number.
For any other trouble related to SCSI,
refer to the SCSI section of
Troubleshooting
B
The scanner and the printer were
turned on after turning on the
computer.
turned on after turning on the
computer.
B
The terminator setting is
improper.
improper.
B
SCSI setting or cable connection
is improper.
is improper.
One or more ASPI for
DOS managers are
loaded which do not
support ASPI for Win16
or 32.
DOS managers are
loaded which do not
support ASPI for Win16
or 32.
Status Display
Invalid LPT Port.
SCSI board is not correctly set.
Correctly set the SCSI board in the
computer. (Refer to the instructions
manual of the SCSI board.)
For any other trouble related to SCSI,
refer to the SCSI section of
Troubleshooting
computer. (Refer to the instructions
manual of the SCSI board.)
For any other trouble related to SCSI,
refer to the SCSI section of
Troubleshooting
Correctly set the SCSI board in the
computer. (Refer to the instructions
manual of the SCSI board.)
For any other trouble related to SCSI,
refer to the SCSI section of
Troubleshooting
computer. (Refer to the instructions
manual of the SCSI board.)
For any other trouble related to SCSI,
refer to the SCSI section of
Troubleshooting
Unavailable LPT port is selected
when using Windows 3.1.
when using Windows 3.1.
Select the other available LPT port by
following the procedure below.
1. Double click the
following the procedure below.
1. Double click the
Main
icon.
2. Double click the
Control Panel
icon.
3. Double click the
Printers
icon.
4. Click Connect... .
5. Click the other port, then click OK.
6. Click Close.
5. Click the other port, then click OK.
6. Click Close.
No ASPI managers are
loaded. This typically
occurs when a DOS ASPI
manager is not resident in
memory.
loaded. This typically
occurs when a DOS ASPI
manager is not resident in
memory.
Load Library Error!, File
Open Error! or Install
Error! appears and
Status Display does not
appear.
Open Error! or Install
Error! appears and
Status Display does not
appear.
The necessary file is not installed in
the computer.
the computer.
Reinstall the KX-PS8000 software.
SCSI board is not correctly set.
ASPI for Win16 or 32
could not properly
initialize itself. This may
be caused by a lack of
system resources.
could not properly
initialize itself. This may
be caused by a lack of
system resources.
Lack of system resources, or other
trouble related to SCSI.
trouble related to SCSI.
Close some application and retry.
For any other trouble related to SCSI,
refer to the SCSI section of
Troubleshooting
For any other trouble related to SCSI,
refer to the SCSI section of
Troubleshooting