Руководство По Работе для Panasonic KXTGA786E
Charge for about 7 hours.
R When the batteries are fully charged, “Fully charged” is displayed.
R When the batteries are fully charged, “Fully charged” is displayed.
Rechargeable Ni-MH
ONLY
ONLY
Confirm “Charging”
is displayed.
is displayed.
Note:
R The handset display may show “Please wait for 1 minute.” when the
R The handset display may show “Please wait for 1 minute.” when the
handset is placed on the charger if it is not registered to the base unit.
R If the batteries are fully charged, but the operating time seems to be shorter,
clean the battery ends (
,
) and the charge contacts with a dry cloth and
charge again.
Registering the handset to the base unit
Ensure that the handset is switched on. If it is not on, press and hold MeN for
few seconds to turn the handset on.
few seconds to turn the handset on.
1
Handset:
Lift the handset and press MeN.
Lift the handset and press MeN.
2
Base unit:
Press and hold M
Press and hold M
N for about 5 seconds.
R Depending on the base unit, a registration tone sounds.
R If all registered handsets start ringing, press M
R If all registered handsets start ringing, press M
N again to stop, then repeat
this step.
3
Handset:
Place the handset on the base unit or charger.
R Continue the operation even when the handset display shows “Please
Place the handset on the base unit or charger.
R Continue the operation even when the handset display shows “Please
wait for 1 minute.”.
4
With the handset still on the base unit or charger, wait until a confirmation tone
sounds and
sounds and
is displayed.
4
Helpline Tel. No.: U.K. 0844 844 3899 Ireland 01289 8333
Installation
TGA681E(en-en)_1220_ver011.pdf 4
2012/12/20 19:20:07