Инструкции Пользователя для Pioneer AVIC-7201NEX Package

Displaying the open source
licenses

You can check the open source licenses of the functions that this

product is equipped with.

1 Display the “System” setting screen.

 Refer to Displaying the “System” setting screen on page

2  Touch [System Information].
3  Touch [Firmware Information].
4  Touch [License].

Updating firmware

CAUTION



The external storage device for updating must contain only

the correct update file.



Never turn this product off, eject the SD memory card or

disconnect the USB storage device while the firmware is
being updated.



You can only update the firmware when the vehicle is

stopped and the parking brake is engaged.

1 Download the firmware update files into your

computer.

2 Connect a blank (formatted) storage device

to your computer, and then locate the correct

update file and copy it onto the storage device.

3 Set the external storage device to this product.

 Refer to Inserting and ejecting an SD memory card on page

 Refer to Plugging and unplugging a USB storage device on

page 7

4 Turn the source off.

 Refer to Selecting a source on page 9

5 Display the “System” setting screen.

 Refer to Displaying the “System” setting screen on page

6  Touch [System Information].
7  Touch [Firmware Update].
8  Touch [Continue] to display the data transfer

mode.

Follow the on-screen instructions to finish updating the

firmware.
p

If an error message appears on the screen, touch the display

and perform the above steps again.

Checking sensor learning status
and driving status

You can check the sensor learning status, such as the degree of

learning. You can also check the current sensor values and the

total number of speed pulses.

1 Display the “System” setting screen.

 Refer to Displaying the “System” setting screen on page

2 Touch [System Information].
3 Touch [3D Calibration Status].

Clearing the status

You can delete the learned results stored in the sensor.

1 Display the “3D Calibration Status” screen.
2 Touch [Distance] or [Speed Pulse], and then

touch [Yes].

3 Touch [Learning] and then touch [Reset All].

Touch [Reset All] to reset the sensor after changing the

installation position or angle.

If you touch [Reset Distance], all learned results stored in

“Distance” are cleared.

Checking the connections of
leads

Check that the leads are properly connected between this

product and vehicle.

1 Display the “System” setting screen.

 Refer to Displaying the “System” setting screen on page

2 Touch [System Information].
3 Touch [Connection Status].



GPS Antenna

Displays the connection status of the GPS antenna (“OK” or

“NOK”) and the reception sensitivity.

If reception is poor, please change the installation position

of the GPS antenna.



Positioning Status

Displays the positioning status (3D positioning, 2D position-

ing, or no positioning), the number of satellites used for

positioning (orange), and the number of satellites whose

signal has been received (yellow). If signals from more than

three satellites are received, the current location can be

measured.

 Refer to Positioning technology on page 80



Installation

Indicates whether the installation position of this product

is correct or not. If installed correctly, “OK” appears. When

this product is installed at an extreme angle exceeding

the limitation of the installing angle, “NOK(Inst. Angle)”

will be displayed. If the installation of this product is

continually changed and it is not firmly fixed into place,

“NOK(Vibration)” will be displayed.



Speed Pulse

The speed pulse value detected by this product is shown.



Illumination

Displays the status of headlights or small lamps of the

vehicle.



Back Signal

When the shift lever is shifted to “R” (reverse position), the

signal switches to “High” or “Low”. The signal displayed will

vary depending on the vehicle.



iDataLink

Displays the status of the optional iDatalink adapter.

< CRB4817-A >

System settings