Инструкции Пользователя для CRUX CCH-01W
Jeep
2007 – Up
Wrangler
-
Installs on your Wrangler's license plate bracket, keeping the rugged appeal of your Jeep.
-
120° wide viewing angle.
-
0.4 Lux minimum for night driving.
1.
Remove the stock license plate light at the back of the vehicle.
2.
Install the camera assembly to where the stock license plate light was.
3.
Connect the built-in license plate light of the camera to the stock license plate power connection.
4.
Connect the power of the camera to your brake light wires:
Red wire to +12V
Black wire to Ground
5.
Connect the video cable of the camera to the extension cord provided.
6.
Run the video extension cable to the back of the radio.
7.
Connect the video cable to your in-dash aftermarket multimedia or navigation receiver's camera input.
8.
Put the gear in reverse to see the image from the camera.
Sensor
CCD
Invert
Image
No
Viewing Angle (H)
170
Resolution
480 TV Lines
Viewing Angle (V)
90
Illumination
0.4 Lux / F1.2
TV System
NTSC / PAL
Power Supply
12 Volts
Guide
Lines
Yes
Waterproof
IP67
CCH-01W Camera Assembly
19 ½ ft. Video Extension Cable
042215